How to use the scanner? 1. First, the first step is to open the scanner cover, put in the certificate you want to scan, and then open my computer from the computer side. After installing the driver, there will be a drive letter of the scanner, similar to the location of the optical drive.
2. Double-click the drive letter of this scanner to open the dialog box as shown in the figure below, allowing you to select a program to open for him, and we can directly select the second item.
3. After selecting the scanner and camera wizard, we will click Next to enter the interface shown below, and then continue to click Next.
4. At this point, the scanner wizard opens. Here is a preview button, the specific location is shown in the figure below. Click Preview to preview the original to be scanned in the box above, and then adjust the position of the check box.
5. After adjusting the position to be scanned, be sure to open the custom settings button in the lower left corner. Here, we set up scan resolution. The default resolution is not suitable for high or low, so we usually set it to 300.
6. Set the resolution and click OK to enter the scanning interface. We can just click next.
7. After clicking Next, you can see the scanning progress interface as shown in the figure below. When the scanning progress bar reaches 100%, the scanning is completed.
8. After the scanning is completed, you will enter the interface shown below, prompting you what to do. We will just click on the next step, that is, do nothing. I have finished processing these photos.
9. At this point, you have completed the scanner wizard. If you click Finish, you will automatically enter the location where the scanned document is stored.
How to use the scanner? The above are the detailed steps to use the scanner. Novice operators must remember to set the resolution and adjust the box to the appropriate position when using the scanner.