1, carve a small hollow hole in the middle of the first step. Be careful, you will make mistakes if you are not careful. Don't cut through the big turning point, you need to connect several knives, otherwise the tip will break and the paper will be raw.
2. After the small hollowing out, you can carve the big hollowing out in the middle. Don't feel bad about cutting the piece, and finally you must carve it! ! Otherwise, the phone bill rework is time-consuming and laborious. If it is not handled well, the edge will be uneven and affect the appearance. Also, when carving a long outline like coral, it is best to start from the root and carve it to the top, otherwise it may wrinkle the coral.
3. After all hollowing out, cut along the contour line of the edge. At this time, you can align the line with a steel ruler, scratch it with a meat cutter (this is easier to align, but it will slip if you can't hold the ruler with your hand), or you can cut it with scissors (if your hand is disabled, it is easy to cut, but the operation is simple).
4. Finally, replace the meat cutter with a needle and make a hole where it needs to be pierced. Pay attention to poke gently, if the hole is small, it will be shallow, and if the hole is large, it will be deep. Punch the hole at last, or it will be gone when you press the hole.
5. Stick butter paper where you need it (if you want to stick it, he will tell you that you want to stick it here). I cut it along the outline and glue it with white, or I can stick the whole piece with double-sided tape without cutting it. However, it should be noted that double-sided tape will affect the light transmittance, so those with double-sided tape can only be attached to the place where the edge will be blocked by the frame, otherwise it will be ugly to turn on the light.
6. After all drawings are processed, assemble the plastic frame. After the four corners are installed, you can put them on the desktop to see if the four corners are on the same plane.
7. Tear off the two layers of protective film of acrylic board and put it into the photo frame. Then according to the figures in the lower right corner of the drawing, from small to large, the figures are forward, the first one is placed next to the acrylic board, followed by the plastic frame and drawings. If there is more than one plastic frame, put two frames between the last drawing and the backplane.
8. Stick the lamp strip and the receiver on the backplane, and connect the USB cable to the receiver after passing through the small hole.
9. Cover the backboard with the receiver above and the light below, and then break the small iron sheet back to fix the backboard. If you want to hang it on the wall, you should install a fixed pin at this time, which is the black one above.
10, put four anti-skid pads on the bottom of the frame, and it is finished.
The above is the practice of paper carving lamps, hoping to help you.