The standard sample paper cutter is composed of pressure plate, upper and lower cutters, positioning baffle, lever pressure plate, ruler baffle, etc. Before the first use, please remove the screw of the fixing tool at the front end of the plastic handle. When in use, first lift the tool, lean the sample on the scale of the table top, push the sample onto the positioning baffle, and then hold the tool handle with your right hand to cut down to get the required sample. ?
After cutting the paper, press the cutter down to the right to the lower bayonet of the positioning baffle, clamp the cutter to the left, and then pull the cutter up to the right when using. When the adjacent edges of the sample are not perpendicular, they should be cut into mutually perpendicular adjacent edges before cutting the sample. The paper cutter should be avoided in wet or dusty environment, and a small amount of lubricating oil should be added to the moving parts every month. If the use is suspended, the upper and lower blades should be coated with a small amount of antirust oil to prevent corrosion.
It is forbidden to cut any metal objects and other high-strength materials to avoid damaging the blade. If the cut is uneven, the tool clamping pressure can be adjusted appropriately. The specific method is: take off the plastic sleeve at the front end of the cutter and tighten the nut. After the edge becomes dull, it can be finely polished with an oilstone. For paper samples with low or soft cut, such as toilet paper, before cutting, the samples can be laid flat and sandwiched between two pieces of paper lined with paper, such as copy paper.
Brief introduction of paper cutter:
Paper cutter is just a general term for the use of knives in daily life. In the use of paper-cutting, we are used to cutting paper with thin lines close to the edge of folded paper, and also cutting paper with knives such as blades. Many methods and tools have been replaced by a special paper cutter, which is a paper cutter. Paper cutter cuts paper through metal, and its metal edge is not sharp, but it uses mechanical close joint to cut paper under the force of metal.
Paper cutters are marked with scales, which are used to cut different sizes of paper. Some paper cutters are also equipped with cursors, which are convenient for measuring dimensions when cutting. Some names of paper cutters are also called paper cutters or cardboard cutters, and some stationery manufacturers in China also sell such products, such as Jerry's and Delight.