The writing method of long character calligraphy is as follows:
1. First of all, the first short stroke should start from the vertical center line in the upper part of the rice grid, and the slope of the short stroke must be Note that it is about forty-five degrees and cannot be written long.
2. Then write the middle horizontal stroke. The middle horizontal stroke should be started from a little below the center line of the rice grid and slightly upward against the shoulder. It is best not to write flat, nor to write too long or too short.
3. Let’s continue to write the vertical stroke. The vertical stroke is the main character of this character. Note that the vertical stroke basically runs through the middle and horizontal to the left, as well as the direction of the stroke.
4. Then when we write the last stroke, we should start from the intersection point of the horizontal and vertical strokes slightly to the right. The stroke should be slightly longer than the horizontal end. Let’s see the red line in the picture below.
5. Finally, we observe the structure of the entire character. The middle and horizontal lines basically divide the upper half and the lower half equally. Be careful not to write wide at the top and narrow at the bottom or narrow at the top and wide at the bottom. This is a lot. People often make mistakes, which will make the whole word look ugly, so we must pay attention to this more important structure.