There is a complete set of process for mounting technology, and the operation must be carried out according to the requirements. The process is first to support and dye the materials,
including:
① Support the damask and silk, lay the front of the damask and silk together, and use a brush dipped in clean water to brush it thoroughly. , then use a dry towel to absorb the water, so that the silk fabric is tight on the table surface, straight and wrinkle-free, and then apply paste. Finally, align the rolled paper with the silk fabric, and use a pulp brush to brush it firmly while unfolding the support paper. , then use a brown brush to lay them firmly, peel them off, and hang them on the wall to dry. In addition, you can also put the pigment into the paste and mix it thoroughly, brush it until the silk is silk, put it on paper, and let it dry, that is, dyeing with the support, which is called Hunduo.
② Support mounting paper and mounting paper, most of which support 3 layers. First
Spread the first layer of paper, use slurry water to brush the paper evenly, add the second layer, align the edges, unfold the paper, and brush firmly. Then use slurry
water to add the third layer, the same steps as above. After the 3 layers are supported, brush again with a brown brush and let dry.
③Dye the material. Soak the pigment and glue in water.
Soak the dyed paper and silk on the painting table. Brush the colored water up to make it even. First, Brush the supporting paper, and then brush the front side of the paper silk silk. Then put it on the wall to dry.
Then supporting the painting heart includes:
① Wet mounting method, used for painting heart that does not fade. Lay the cut center of the painting on the painting table, moisten it, flatten it, apply sizing water, brush the strips along the four sides of the center of the painting, brush the supporting paper on it, and then use a brown brush to brush the supporting paper from top to bottom.
②The pinto method is used for painting centers that are easy to spread or fade. The method is to brush slurry water on the paper and cover it with the heart of the painting. There are two types: flying support and covering support.
Then inlay and calendering, including:
①Inlay, cut off the supported painting center
Excess strips, and then paint The heart is surrounded by various materials such as required rings, upper and lower water barriers, heaven and earth heads, Jingyan, damask small edges or sky small edges, etc. Then brush the back with slurry water and stick on the backing paper.
② Calendering, calendering, that is, calendering the back of the cover
The final mounting piece is polished with a calender stone to make it smooth and soft. Installation refers to assembling the sky and earth rods, axle heads, drilling on the rods, threading ropes for hanging, etc. on the framed frame. At this point, the mounting work is complete.
Form is also called style. The main ones are:
① Banners are also called hanging shafts or shafts because they are hung vertically. From top to bottom, it includes Tiantou, Tiantou, Jingyan, upper water barrier, fence, painting center, lower water barrier, ground head, ground pole, axis head, etc. Generally, Tiantou Da, Ditou Small.
②Long roll, also called hand roll, or roll for short. It is composed of the head, the auxiliary water barrier, the front water barrier, the silk edge, the leading head, the painting center, the back water barrier, the inscription and postscript paper center, and the tail.
③Album pages are connected and folded end to end. Its form is similar to a picture album. Each page has a painting, or a painting and a postscript. The beginning and end are hard brocades, with borders, hearts, distractions, etc. . There are many styles of album pages, including those that are folded left and right and open to the right, called butterfly style, those that are folded up and down, and those that open upward are called push-top style, etc. In addition, there are also framed styles such as screen strips, couplets, and horizontal drapes.