1, horizontal folding: draw down to the right from the pen, fold down to the left to write a long horizontal line, and finally close the pen up.
2. Fold: Start writing from the center of Tian Zige to the left, fold the pen to the right to write a short vertical line, and finally close the pen to the right.
3. Skimming: Start from the center of Tian Zige, then write a short paragraph to the left, and finally close the pen to the left.
basic configuration
1, the first part is horizontal folding.
This part usually starts from the center line of Tian Zige, writes a short horizontal line to the right, then writes a vertical bend down, and finally writes a short horizontal line to the right. In the two short transverse directions, the first short transverse direction should be slightly higher than the second short transverse direction.
2. The second part is the second horizontal folding.
This part generally starts from the lower right of the first part, writes a short horizontal line to the right, then writes a vertical bend upwards, and finally writes a short horizontal line to the right. The starting point of this part should be aligned with the ending point of the second short cross of the first part.
3. The third part is apostrophe.
This part generally starts from the lower right of the second part, writes a short vertical line to the left, and then writes an oblique stroke down. The starting point of this part should be aligned with the ending point of the second short cross of the second part.
Key points of writing
1, two transverse bends should be parallel and symmetrical, the distance between two short transverse bends should be equal, and the length of two vertical bends should be equal.
2. The first short stroke should be slightly higher than the second short stroke to prevent the whole stroke from being too low.
3. The starting point of the second short cross should be aligned with the ending point of the first short cross to keep the balance of the font.
4. The starting point of apostrophe should be aligned with the ending point of the second short cross to maintain the continuity of the glyph.
5. The direction of skimming should be down to the left, not down to the right, to prevent the strokes from being too long or too short.
Common mistakes and correction methods
1, the two transverse folds are not parallel or asymmetrical.
This is usually caused by not controlling the strength or angle when writing. The way to correct it is to strengthen practice, pay attention to observing and comparing your own handwriting, and gradually adjust and improve it.
The first short cross is too low or too high.
This is usually caused by not mastering the skills of starting and collecting pens. The correction method is to pay attention to the position and angle of the pen, as well as the strength and speed of the pen, and adjust the length and inclination of the strokes appropriately.
3. The starting point of the second short cross is not aligned with the ending point of the first short cross.
This is usually caused by not controlling the position and angle of the pen. The way to correct it is to strengthen practice, pay attention to observing and comparing your own handwriting, and gradually adjust and improve it.
4. The starting point of skimming is inconsistent with the end point of the second short cross.
This is usually caused by not controlling the position and angle of the pen. The way to correct it is to observe and compare your own handwriting and gradually adjust and improve it.
5. skimming is in the wrong direction
This is usually caused by not mastering the writing skills of apostrophes. The way to correct it is to observe and compare your own handwriting and gradually adjust and improve it.