(There are illustrations in the document)
Thread-bound book making
Materials:
1. Tokyo Line
2. Needle (slightly larger than sewing needle)
3. Xuan paper (or other required paper, preferably Xuan paper)
4. Cloud paper (for cover)
5. Drill (or electric drill)
rule
7.pencil
Steps:
1. Cut blank rice paper or written document into the size we want.
2. Cut the cloud paper used as the cover into the same size as the rice paper (you need to prepare two pieces, one for the cover and the other for the back cover).
3. Draw a square with a side length of 1 cm on the top and bottom of the cloud paper as the cover, as shown in Figure 4.
4. The middle part is divided into three parts, as shown in Figure 4.
5. Finally, the intersection of line segments as shown in Figure 4 is the drilling position, that is, the place where the needle is to be stuck.
6. Align the document with the front cover and back cover, fix it with a long tail clamp, and then drill four points in Figure 4 with a drill (the number of holes must be even).
Sew it up again! !
7. thread the Tokyo line on the needle. The length of the line is about two and a half times the length of the book.
8. At first, start with the second hole.
9. Fix the wire end with long tail pliers.
10. After that, it can be completed by using the following principles.
principle
The lines of each line segment in Figure 4 cannot be repeated. ※
Every line segment must cross this line. ※
As long as you follow the principle, you will finally find that the thread head and the thread tail will meet at the second hole and tie a flat knot. ※
Add some inscriptions and a thread-bound book will be finished! !