What kind of glue should be used for pasting posters? White latex or double-sided tape. White latex is a thermoplastic adhesive produced by the polymerization reaction of vinyl acetate monomer under the action of an initiator. It can be cured at room temperature, and has fast curing, high bonding strength, and good bonding layer properties. Toughness and durability and not easy to age. Double-sided tape is made of paper, cloth, or plastic film as the base material, coated with solvent-based polyacrylate adhesive on both sides, and then covered with an easy-to-peel material. It is easy to operate.
White latex, double-sided tape. White latex is a thermoplastic adhesive produced by the polymerization reaction of vinyl acetate monomer under the action of an initiator. It can be cured at room temperature, and has fast curing, high bonding strength, and good bonding layer properties. Toughness and durability and not easy to age. It is mainly used in wood processing, furniture assembly, cigarette spouts, building decoration, fabric bonding, product processing, printing and binding, handicraft manufacturing, leather processing, label fixing, ceramic tile pasting, etc. It is an environmentally friendly adhesive . Double-sided tape is made of paper, cloth, or plastic film as the base material, coated with solvent-based polyacrylate adhesive on both sides, and then covered with an easy-to-peel material. It is easy to operate. How to paste posters:
1. Measure the horizontal position first. When pasting, you can paste it from left to right and top to bottom according to the direction of the screen and pasting habits.
2. If the screen is in horizontal format, you can paste it sequentially from left to right. The application of adhesive requires skill, and often requires two people to work together: one person assists and the other applies the adhesive. Use a small towel instead of your hands when pasting to make it easier to smooth the picture.
3. Taking the vertical screen as an example, first peel off a small piece of transparent protective film behind the adhesive tape, position the upper two corners of the screen on the wall, and the assistant gently pulls the lower two corners to move the entire screen. The picture is pressed flatly onto the wall. The paster uses a wet rag to smooth the pasted part while removing the protective film, and slowly and gradually pastes the picture onto the wall. What kind of glue can be used to put posters on the wall without damaging the wall?
You can use toothpaste to paste posters. The specific operation method is as follows:
1. First prepare a tube of toothpaste and posters.
2. Squeeze out an appropriate amount of toothpaste on your hands.
3. Then apply toothpaste to the four corners of the poster with your hands.
4. Place the poster on the wall and smooth the four corners.
5. Because the toothpaste itself is sticky and its composition is calcium carbonate, it becomes the same material as the wall after oxidation. Therefore, the poster will not damage the wall but will stick very firmly. How to put posters on the wall. Question 1: I want advice on how to put posters on the wall. In order to get confused, you can actually refer to the method and layout of the photo wall. Question 2: How to put posters on the wall correctly? First cut the paper to the size you want, hold it steady with both hands, and work alone. Hold the top of the poster, and one person holds the bottom of the poster (if there are two people, ask another person to help you stick it together) and stick it firmly from top to bottom. Finally, use a scraper to scrape it flat. Question 3: How to stick the poster? Two methods, 1. Use the calligraphy tape bought from the hardware store and stick it on the wall where you want to stick it. Then stick the double-sided tape on the back of the poster and stick it on the calligraphy tape. The calligraphy tape will not show up after being removed. Leave no trace on the wall. (My most common method) 2-Use toothpaste to stick it on, and just wash it off with water when not in use (I saw it online, but I haven’t tried it yet) Question 4: How should the poster be posted? When directly pasting it off with transparent tape, use a knife to cut off the part attached to the wall. The rest is the poster. Because the transparent tape is transparent (nonsense), it doesn’t matter if you don’t need to tear it off. Question 5: How to remove the poster from the wall? Blow it off with a hair dryer and heat the glue. Then it can be easily removed! Question 6: How should posters be posted? I think it would be more beautiful to use double-sided tape. After all, if you use double-sided tape, it doesn’t matter if you stick it on the wall. I also saw that there is transparent tape and if you stick it, it is best not to seal all the four sides. In this case, As you said, it will become damp when it gets wet. But if there are four sides, you can only stick 2/1 of each side, or start from the 4 corners (for large posters, you can just stick 10 cm long double-sided tape. Oh) I also have stickers in my room. I have been using them for many years and I have never had any problems with them. They are still in good condition. As long as you tighten them a little when you apply them, just use your hands after applying them to a corner. Wipe the other end with your hands so that it is smooth and it will not be arched~~ Question 7: Some of the stupid ways to put up posters! He also serves as a publicity committee member! If the Cultural Revolution had you, it would have failed long ago! Cut out N (representing the number of posters) pieces of paper (it doesn’t matter the color, it’s best to use white), glue the four corners first, and stick it on the wall. (Use transparent tape) Then stick the poster on the paper (use double-sided tape). Don’t stick it around the sides, stick it in the middle. You need to glue a few more places around the white paper to make it more stable! Be careful not to stick the poster to the wall! The white paper is an isolation layer that will neither damage the wall nor the poster.
The white paper also protects the back of the poster once removed from the wall! (Choose printing paper that is not large enough to stick together.) For the sake of me being your apprentice, give me the best answer! (It’s worth typing so many words!) Please accept it, thank you! Question 8: How to paste the poster on the wall? Haha, I have researched this. Glue or tape often sticks to the wall and cannot be removed. Either the poster is torn or the wall is dug out. It doesn't matter. Take a small amount of toothpaste (of course it must be able to stick to the poster) and apply it on the back of the poster and stick it to the wall. That’s OK. Note: Just use whatever color toothpaste you have on the wall. Don’t say I’m not helping you. Question 9: How can I stick the poster firmly on the wall? You can choose to use PP adhesive to make posters. There is a layer of plastic film on the back of PP adhesive. Tear off the film and apply it directly to the poster. Because the entire back of PP adhesive is glued, it is better than other adhesives. Much more solid. Question 10: How to put up posters without damaging the wall and posters, and still be strong? Cut out N (representing the number of posters) pieces of paper (it doesn’t matter the color, it’s best to use white), glue the four corners first, and stick it on the wall. (Use transparent tape) Then stick the poster on the paper (use double-sided tape). Don’t stick it around the sides, stick it in the middle. You need to glue a few more places around the white paper to make it more stable! Be careful not to stick the poster to the wall! The white paper is an isolation layer that will neither damage the wall nor the poster. The white paper also protects the back of the poster once removed from the wall! (Use printing paper that is not large enough to stick together.) Find two clips and clip one to the upper left corner and one to the upper right corner. Then hang it up.
As for hanging the clip in the indicated place? You can smash nails (you can’t have your cake and eat it too), or you can use superglue