How to put the carpet?

Carpets are placed on the ground, and several carpets of different sizes can be stacked. In addition to large-scale laying, carpets are flexible and changeable. Can be placed in the living room, under the coffee table, and with the sofa. In the bedroom, next to the bed, there is a bed. In the kitchen, beside the cupboard, with the kitchen. Bathroom, sanitary ware, and the environment of the bathroom. Why are there burrs after other information carpets are laid? Residents who use carpet floors have burrs around their rooms, and uneven closing and uneven edges and corners after carpet laying are common quality problems. The main reasons for these problems are: (1) When cutting carpets, the knives are not sharp. When cutting with more than two knives repeatedly, some short fluff will be generated at the edges, which cannot be embedded in barbed tops when laying. (2) The barbed wool tops are too close to the wall, and the edge of the carpet can't be embedded, which leads to the exposed edge of the carpet, or the barbed wool tops are too far away, and there are gaps after the carpet is laid, which leads to irregular edges after closing. (3) The periphery of the carpet was accidentally embedded, resulting in some exposed edges. (4) The barbed tops at the corners are uneven or the high walls are too close, and the corners of the carpet are not cut well, resulting in uneven corners of the carpet. How to prevent arching after carpet laying? Uneven carpet laying and arching not only affect the beauty of the room, but also affect the use of residents. This problem is mainly due to: (1) uneven stress on both sides or inconsistent stress speed during laying, which makes the direction of the carpet shift when spreading and local wrinkles appear on the carpet. (2) When the carpet is laid, it is not tight, or when the carpet is hot. (3) The carpet will swell and shrink when it is wet, which will cause the carpet to wrinkle. To prevent the carpet from arching, it must be: (1) mark the baseline according to the room conditions. When laying, the carpet should be spread along the line, and the speed should be uniform when both sides are forced, and kicking is not allowed. (2) When laying, the carpet should be tightened and ironed, and then fixed on the barbed tops. (3) After the carpet is laid, it should be protected from damp during normal use. How to prevent obvious joints after carpet paving? After the carpet is laid, if the seams are obvious, it will affect the beauty of the whole room. The main reasons for this problem are: (1) the size of the carpet is biased or not straight when cutting, and there are fine seams at the joints. (2) When ironing the carpet, don't flatten the seam at the end. (3) The ground is uneven, and cracks appear when the carpet is laid. In order to prevent obvious joint problems, it must be done during construction: (1) It must be cut according to the room size, and the size should not be too small or too large. (2) When splicing two carpets, straightedge should be used to control the cutting straightness, or overlapping cutting should be used to ensure the consistency of the joint. (3) When ironing the carpet, the seams should be tight before ironing. (4) Before laying the carpet, the ground should be leveled before laying the carpet.