1. The manufacturing steps of the hole pen box are as follows: select the front or side of the packaging paper box, punch holes in it with nails, and keep a certain distance between the holes; Glue the long sides of two cartons together with double-sided tape; Sticking clothes labels and butterfly patterns on the bonding part of the box is beneficial to cover the gaps in the bonding part; Insert the brush into the hole, and the hole pen box is finished.
2. Pen holder: Wipe the surface of the tin can with a paper towel to make the wrapping paper firmly stick to the tin can; After covering the tank cover, measure the height of the tank; Cut the wrapping paper according to the size of the tank. In addition to wrapping paper, you can also hand-draw patterns according to your own ideas and then cut them. Cut the cut wrapping paper around the circumference of the jar 1 cm; Stick the double-sided adhesive tape to both ends of the back of the wrapping paper; Tear off the tape and stick the wrapping paper on the tin can.
3. Book cover: the textbook is facing the whole blank paper, and the corresponding creases are pressed at the left, right, front and back positions of the textbook. Spread the book against the center line of the crease, and then face the book with one side of the thick paper, leaving a certain blank position. Cut off the extra edges and corners with scissors. The front page of the book covers the side cover, and the side edge of the book cover is pressed down into the gap. Then cut off some extra edges and edges, and then you can see a complete new book package.