Step 2: Enter "-"(to generate thinner lines) or "_" (to generate thicker lines) in line 1, and then press enter (to select all the contents of this line (excluding the last mark) and press enter-copy) to generate line 1. Press CTRL+V to paste the copied content, then press ENTER to generate a second horizontal line, and so on until all behaviors of each page are set.
Please pay attention to the red circle in the picture. On the left is the left indent slider (the first indent slider at the bottom and top), and on the right is the right indent slider. Through the comprehensive use of the left indent slider and the right indent slider, you can make the effect of the title line, the first line and the whole line you illustrated.
(1) Schematic diagram of title line effect:
(2) Schematic diagram of first-line effect:
(3) Schematic diagram of complete line effect:
(4) Schematic diagram of the whole page effect: (A4 format, margins: upper 2.54cm, lower 2.3cm, left 3. 17cm, right 3. 17cm) Note: For the blue boxes and circles in the figure, the "line spacing" in the last line of the document needs to be changed to "fixed value", and the setting value needs to be set.
Step 3: Set the background picture. The aspect ratio of the picture should be consistent with the aspect ratio of the page. Insert picture first: insert-picture-from file-select picture file-OK; Then set the picture format: Format-Picture-Size-Check "Lock Aspect Ratio" and "Relative to the original picture size"-OK, and then drag the adjustment point in the lower right corner of the picture to make the picture fit the page size; Finally, set the text wrapping mode of the picture: change the default text wrapping mode of the picture to "below the text".
Schematic diagram of effect: