How to deal with the crack of oak barrel 1 Let the water in the oak bath bucket dry completely, then dry it, and then clean it up until there is no water at the joint. Be careful that there is no water in the joint, and then fill the joint with light white sawdust.
2. After filling, slowly immerse 502 glue into the joint. After about 10 minutes, fill in the sawdust again, and then dip the glue into the joint.
3. If there is burr on the repair surface, it can be slowly polished with sandpaper. Be careful not to polish the surrounding wood to avoid damaging the paint film. Then dust the repaired surface and brush it once and twice.
How to prevent the barrel from cracking 1 It is normal to have water seepage when testing water for the first time. After adding water, it must be soaked for more than 12 hours to make the barrel fully wet. At this time, the water seepage of the bucket will stop. If in doubt, please contact the manufacturer in time.
2. Use it every day or once every two or three days. Pour out the visceral water in the bucket and rinse it with clean water after taking a shower.
3. Because the wood itself will expand when heated and contract when cooled, it cannot be directly exposed to the sun, nor can it be blown away by the cold wind. If you don't use it for more than 2 months, you can soak it in wooden barrels and seal it with large plastic bags to prevent the air from taking away moisture.
4. Usually, it is best to put a little water in it to make it absorb water and keep the wood saturated and moist. But don't use too much water, because the bathroom itself has a certain humidity. Be careful not to leave dirty water after bathing, so as to avoid wood absorbing sewage and accelerating aging or mildew.
5. After the bucket is used for a period of time, the iron wire fixed outside the bucket will loosen. At this time, you can turn the bucket upside down first, then tie the wire tightly and add hot water to continue using it.
6. The wood thickness of the barrel wall will be different. Generally, wooden barrels with a wall thickness of 2 ~ 3 cm are selected for the best insulation effect.
What kind of wood is oak? Oak belongs to Quercus acutissima, belonging to the beech family. The tree core is yellow-brown to reddish-brown, with obvious annual rings, slightly wavy, heavy and hard. Widely distributed in the eastern United States, the wood is hard and heavy, with good machinability and slow drying; The color, texture, characteristics and characteristics of red oak will vary from place to place. Red oak in the south grows faster than that in the north, and the wood is hard and heavy, so it is generally sold in the north and south according to the origin. The southern material is red and has color difference, which is suitable for dark painted products; The northern material is mainly light red and white, with uniform color, suitable for light-colored products, and the north-south span is large.