Question 2: How to start a new brush? To start a new pen, you must start writing. Soak the bought pen in "warm water", and the soaking time should not be too long until the nib is "completely open". Don't melt the glue at the root of the pen, otherwise it will become a "brush" and your hair will fall off easily. Violets are hard and need to be soaked in water for a while.
Moistening is a necessary job before writing, and you can't write as soon as you touch the ink. The method is to soak the brush with clear water first, and then lift it. Don't soak it for a long time to avoid gel at the root of the brush. After that, it takes about ten minutes to hang the pen upside down until the tip of the pen recovers its toughness. Pens must be dry when stored. If the pen is not polished, the hair will become brittle and brittle after pressing again, and the elasticity will be poor. Hangzhou Xiling printing plant
Question 3: How should the new brush be opened? It should be said that there is no need to open bubbles, and the front is soaked in warm water. Generally, all pens are soaked, and some pens are partially soaked. You can unscrew it by hand.
Question 4: What is the best way to start writing with a brush? The first process before making and packaging the brush is solid, that is, the bristles on the brush head are bonded together with sticky substances. After drying, put on an envelope and then pack it, and it's done. Therefore, when using a writing brush, the nib is hard and needs to be opened before it can be used. Writing is very simple, just soak it in warm water for ten minutes. Then change the water, and wash the soaked brush repeatedly in lukewarm water to wash off the unfixed fluff on the brush head. When no fluff comes out, tell the pen to use. Don't shake the pen after opening it, so as to avoid the tip falling off or being damaged.
Question 5: 1 How to use it? A new brush began to write?
When the brush leaves the factory, the tip of the brush is generally stained with antlers. This is not only convenient for packaging, but also makes the bristles straight and practical. When in use, gently pinch off the bristles with your hands, then soak the bristles with clear water (cold water), spread them out completely, brush off the vegetable liquid in the pen, remove the floating hairs that are not stuck at the roots, squeeze clean water to make the bristles smooth, and then use the ink.
2. Matters needing attention when using a brush for the first time
When using a writing brush for the first time, the nib should be soaked in ink for a period of time, so that the nib can absorb enough ink before using it. Especially for large pens, the soaking time is longer, so that the pen can absorb enough ink. Because the hair inside the nib can't be completely soaked by ink in a short time, even if the surface of the nib is full of ink, the nib is still impractical and swollen, and the use effect is not ideal. After several uses, the nib will be completely soaked with ink, which will become straight, practical and integrated, with a little greater elasticity and the best use effect.
3. How to moisten the pen
For the necessary work before writing, soak the pen with clear water first, and then lift it. Don't soak it for a long time, so as not to gel the pen root. After that, hang the pen upside down until the nib recovers its toughness, which takes about ten minutes. Pens must be dry when stored. If the pen is not polished, the hair will become brittle and brittle after pressing again, and the elasticity will be poor.
4. How to wash the pen
After washing, first absorb the remaining water from the dry pen, and then straighten it out. Then hang the pen on the pen holder, and it is best not to insert it directly after washing, because the residual moisture flows into the pen holder, which is easy to cause the broken rod and the nib to fall off. Don't use soapy water when washing pens, because soap is alkaline, which will make wool lose a little oil, thus making wool brittle and broken. The residual water can continue to drip down until it is dry. It should be noted that it should be dried in the shade in a cool and dry place to preserve the original shape and characteristics of the pen, and it should not be exposed to the sun.
Question 6: How to turn on the double-sided brush? The steps should be detailed, such as opening, moistening and inking. The use and maintenance of the new brush are the same. It should not be divided into wolf hair, but twice as much bristles, rabbit hair and wool. The basic points are as follows:
The first step should be to send the pen, which is what you said. This is the most important step in using a new pen.
When a new pen arrives, the tip of the pen is usually sealed by a kind of glue called antlers. The purpose of this is to facilitate packaging and transportation. Besides, it can keep the hair straight in front. Before use, you need to open the pen and soak it in cold water (room temperature water). Be careful not to touch the bottom of the container when soaking (touching may bend the nib and affect writing, and the time required varies according to the concentration of glue. Some friends use warm water or hot water to write quick pictures, which is extremely incorrect, because hot water is very likely to burn the brush and bend it, which will affect the writing effect. The correct way to open a pen depends on the wool. Generally speaking, except rabbit hair, it can be dipped and twisted at the same time. The specific method is to immerse the nib in water and apply force evenly to the waist of the pen, knead it and rotate it, so that the nib will slowly spread out. Don't worry, wool can't be hurt as long as it's not very violent. After the hair is completely released, it needs to be gently stroked by hand. First of all, it is to remove the broken hair in the hair. Broken wool exists because it is necessary to pull this grade of wool when repairing pens, but it has been pulled out during the pulling process, but it has not been removed. Generally, there are not many broken hairs, not more than ten, which will not affect the use of pens at all. The second is to thoroughly clean the glue of the new pen. The glue of the pen is easy to stick between the hair, which has a great influence on writing, and will lead to uneven stress on each nib when writing, which will split the belly and nib. After the newly developed pen is thoroughly cleaned, it is best to hang it in water and use it after hanging it dry.
Secondly, soaking in ink, which is what you call "moistening the pen" (in fact, "moistening the pen" now generally refers to the reward of asking people to write articles, write and paint). When it is used for the first time, it is best to soak the pen in the ink for a while, so that the ink can fully enter the pen column and make the pen fully embrace. This may prevent the hollow expansion of the pen belly, which is moistening ink. After several uses, due to the running-in between the pen tips, the gap becomes smaller and the elasticity is slightly larger, and the use effect begins to get better (this is particularly obvious in wool pens).
Finally, the daily use and maintenance of brushes. After using the pen, please immediately wash the ink with clear water and gently squeeze the residue outside the root by hand. Generally speaking, as long as the quality of the pen is up to standard, the nib will not fall off without great force, so don't be afraid of squeezing. Ha ha. After washing, spin dry or suck dry with paper, straighten and hang dry. It can only be used again after it is completely dried (if it is used frequently, two pens can be used alternately). Never put a wet pen into a pen container immediately (especially a large pen container). This is a big taboo, because if you do this, water will flow into the pen cavity, and the water in the pen cavity will not evaporate easily. Long-term immersion will directly lead to mildew at the root of the pen, leading to hair removal. When you use the pen again, you need to soak it in cold water, squeeze it out and ink it. This is similar to ink wetting, which can reduce the gap between hair and hair. And it is more convenient to clean after use. In addition, if you encounter something in the process of writing and don't wash your pen and hang it dry, the ink will have dried up long after you come back, and it will be difficult for your pen to tie a knot. At this time, you must not press it quickly and break the nib. At this time, you need to soak in water to send a pen.
Question 7: Beginner brush opening: the newly bought brush can be soaked in clean water before use. Of course it's all open. Remember to rinse the brush after use.
Question 8: How to soak the nib naturally with cold water?
Question 9: Should the brush be soaked in cold water or warm water? Soak in cold water. The brush is glued with animal glue and can't stand blisters. If the soaking time is too long or the water temperature is high, the glue at the joint between the pen root and the pen holder will be soaked away, resulting in hair loss and pen head falling off. . Just soak for a while and rub off the pen light valve.
Question 10: How to use a clean water brush for the first time? Do not use hot water. Soak it until it becomes soft. Wash it by hand several times, remove the glue from the brush and you can use it.