Step 1: Set up
Because you write big letters from right to left, choose vertical to represent a word and a line. Please refer to the following figure to set 1024X768, which is a flat rectangle with a width of 1024 and a height of 768. Choose a black and white brush.
Note: the thickness of the brush is set at about 40 according to personal preference. The multiple is set to 1.2 times, which means that the generated word is 1.2 times handwritten.
When finished, press: to start writing. (below)
Step 2: Write in big letters.
Please write down the size of the red box one word at a time. Write in reverse: Taoism is natural.
Note: please wait a moment after writing a word, so that the word you just wrote can jump to the background and continue writing. If it exceeds 10 second, the editing tool will pop up.
Do not press finish or stamp at this time. In the lower left corner, there will be text. You can turn the page by wiping your finger up and down to see these four words. If you feel bad, you can rewrite it or do other operations. Please press: to continue writing.
Step 3: Sign.
Press to change the settings. (If you are still editing the interface, please press: Continue to write. )
Note: Because the inscription is fine print, we need to adjust the brush thickness to 10. But remember not to adjust the proportion. Press again: Start writing.
Special attention: now write two words at a time, that is, write the second word immediately after writing one word, so that the software can think that these two words are one word for synthesis. It is recommended to write only two words for signature.
Step 4: Add a seal
After the signature is written, wait for the editing interface to appear. If there is no seal, you can click to finish the work. Otherwise, click Add Seal.
Special attention: the seal is a transparent picture file, because everyone's seal is different, so it should be stored in your own photo album. You can use other software to make seals, and pay attention to the size of the content.